Problem with positioning moving heads
Posted: Wed Sep 26, 2007 9:32 pm
Hi to all ! I'm new in this software, so I have some doubts
I want to begin excusing me for my English, I'm going to try to do the best I can.
I'm using a Geni OBY-3 250 spot and I'm currently programming offline.
When I plug in the interface, the moving head does not place in the same spot I see in the 3D view.
I have a (more or less) 5 degrees of error. In distance it matters! about 5 meters of error at 10 meters of distance.
In example: If I put the arms of the head in parallel to the base in the 3D view, the real head goes that way, but a little bit to the right.
The tilt is perfect, only ocurrs on the pan.
There is any way to change this from the library (change the dmx values only for this 2 channels (pan/pan fine)?
Or limiting the values so 127 is the actual 127 dmx value for the unit?
Thanks in advance.
Eduardo
from Argentina
I want to begin excusing me for my English, I'm going to try to do the best I can.
I'm using a Geni OBY-3 250 spot and I'm currently programming offline.
When I plug in the interface, the moving head does not place in the same spot I see in the 3D view.
I have a (more or less) 5 degrees of error. In distance it matters! about 5 meters of error at 10 meters of distance.
In example: If I put the arms of the head in parallel to the base in the 3D view, the real head goes that way, but a little bit to the right.
The tilt is perfect, only ocurrs on the pan.
There is any way to change this from the library (change the dmx values only for this 2 channels (pan/pan fine)?
Or limiting the values so 127 is the actual 127 dmx value for the unit?
Thanks in advance.
Eduardo
from Argentina