Page 1 of 1
Compatibility with LumiDrives ColourDriver 36
Posted: Sat Jan 01, 2005 8:57 pm
by chammond
I would like to control my LEDs with the USB version of Easy Stand Alone. I notice that SLESA has an XLR connector whereas my DMX driver has a RJ45 connector. Is a converter available to allow these devices to be connected together?
Posted: Wed Jan 05, 2005 10:36 pm
by roberto
Just check in the manual of your leds, how is the pin assigment on the RJ45 connector (it varies on different manufacturers).
It should use only 3 cables, DMX +, DMX -, and GND
Cut a RJ45 cable and solder to the cables a 3 pin cannon conector.
The converter is ready.
Posted: Wed Jan 05, 2005 11:09 pm
by chammond
Many thanks for your suggestion.
It has the following connections:
Pin 1: Data +
Pin 2: Data -
Pin 7: Common
Pin 8: Common
The data sheet is:
http://www.lumidrives.com/Documents/mai ... g%2003.pdf