Sunlite Forum

I recently purchased a SLESA-U5 and have installed the Easy Stand Alone software.

However, no matter what fixture I connect to the unit I can not get any response. I have another DMX controller here (Enttec DMXIS) that can get all of my fixtures to respond.

I did use the scan library to create profiles for my fixtures as they are not common fixtures. However, even setting up the fixtures as 5 individual dimmers still gives me no control.

On the front of the unit the display says "PC", the amber light (power) is solid and the green and red (# and DMX) lights are flashing rapidly. I do have the switch on the unit set to USB power.

Please tell me I'm doing something stupid and incredibly easy to fix, and not that I have a bad unit.

Thanks!

Jeff Nevins
American Customs Lighting, Inc.

If the yellow LED is on, the interface has power. If the unit says PC and the green light is on, then the interface has a good communication with the software. The RED LED shows the DMX signal so if it is flashing rapidly this should also work fine. Send me your show by e-mail along with the fixture profile you are using. Also check out the no DMX output troubleshooter within the SIUDI tutorials which can be found here: http://www.nicolaudie.com/tutorials/siudi/

If I see no problems with your show and you have no luck with the troubleshooter, we will look into having the unit swapped