Power + DMX
Moderators: simonB, nick, florent, Ben
Power + DMX
Is there a preferred adapter for injecting the 6v via the RJ-45 (Power + DMX/pin 4 &5)? My DMX LED module is a 12-24v device. Sure wish standard POE was supported on the ethernet port.
Re: Power + DMX
Hi,
Thank you for your question. We sell an adaptor called the RJ2BLOCK which makes it very simple to connect DMX (out) + Power (in) to the back of your Stick-DE3 or Stick-CU4. Please see attached image.
The RJ2BLOCK is not currently on our webstore. However, if you setup an account (https://store.nicolaudie.com/signin) and then message me your account email on this forum, I can create an order for you, with a payment link. At the time of writing, the cost is €18 + shipping (+vat, if applicable).
Kind Regards,
Nick.
Thank you for your question. We sell an adaptor called the RJ2BLOCK which makes it very simple to connect DMX (out) + Power (in) to the back of your Stick-DE3 or Stick-CU4. Please see attached image.
The RJ2BLOCK is not currently on our webstore. However, if you setup an account (https://store.nicolaudie.com/signin) and then message me your account email on this forum, I can create an order for you, with a payment link. At the time of writing, the cost is €18 + shipping (+vat, if applicable).
Kind Regards,
Nick.
- Attachments
-
- RJ2BLOCK-cu4.jpg (197.02 KiB) Viewed 3630 times
-
- RJ2BLOCK.jpg (119.13 KiB) Viewed 3630 times
Nicolaudie Tech Support