External i/o Port.

jharris · Post by **jharris** » Tue Apr 19, 2005 2:20 pm

Hi

Please can you help. I cannot switch between scenes using the external i/o port althought the previous/next switches are going between scenes.

I have measured 0v on pin 2 and 3.3v on all other pins. shorting pin 2 to any other pin (not 10) dosnt do anything.

The Hardware manuel isnt clear. The table dosnt agree with the list titled 'external connector pin assignment' (page 10).

Does shorting pin 2 to

pin1 = scene 1
pin2= scene 2
pin3= scene 3 etc.

is an address a scene?

My unit is a SLESA USB running in stand alone mode with a 9v psu. It has 8 simple scenes programmed.

Am i doing somthing wrong? or do you think the unit could be broken. Is there a way of checking??

Please can you help since soon since i have to get the device installed on site soon.

Thanks very much for your time and help.

roberto · Post by **roberto** » Tue Apr 19, 2005 5:01 pm

YOU HAVE TO ASSIGN TO EACH SCENE THE BUTTON THAT WILL TRIGGER IT.
LOOK IN THE EDITOR SCREEN, THE TRIGGER BUTTON, AND ASSIGN IT.

jharris · Post by **jharris** » Wed Apr 20, 2005 8:20 am

Thankyou for your time and effort. Problem is solved and everything is working fine.