Hi Sunliters,
I have just set up two scenes for some moving head fixtures, the only difference is the positions of the beams.
I then enabled the Scene fade, and expected a smooth transition from one position to the next. This works fine in Sunlite 2004.
What happens was that the X & Y channels zeroed, and then moved to the new position!! Not the desired effect!!
Am I doing something stupid, or missing an important 2006 setting? I am using the 13th Jun 2006 software version.
Cheers, Vince
Fade function between scenes not working properly??
Moderators: simonB, RichterMC, florent, dylan
-
- Junior Forumor
- Posts: 37
- Joined: Mon Jun 30, 2003 8:33 pm
- Location: Potters Bar, Herts, England
Hi Bruno,
Thanks for such a prompt reply. I did have the Page priority set to LTP, but I now now discovered my problem is something to do with the Master page that I don't yet understand.
If I disable DMX output for the Master page, then the fades work as expected.
What I also found is that unchecking the 3D icon on any page didn't actually remove the fixtures from the Easy View display. This may also be related to the Master page setup.
I'll catch up with you at Plasa in London and have a chat there.
See you soon,
Regards, Vince
Thanks for such a prompt reply. I did have the Page priority set to LTP, but I now now discovered my problem is something to do with the Master page that I don't yet understand.
If I disable DMX output for the Master page, then the fades work as expected.
What I also found is that unchecking the 3D icon on any page didn't actually remove the fixtures from the Easy View display. This may also be related to the Master page setup.
I'll catch up with you at Plasa in London and have a chat there.
See you soon,
Regards, Vince