Hi,
I am running a trampoline Park in Australia http://www.kloud9ine.com.au . I purchased 70 wall washers from MICZE in China. I have had many troubles with the lights. I am wanting to run the lights for entertainment purposes and also just have them on a fade sequence between colours. I was given a fixture profile from Micze China however i am unable to run UV light out of the lights.
This is the light Model:
LWW-1-10P(RGBAWP)
10pcs (RGBAWP,6IN1)
high power 6W LED,
Independant mode and DMX mode available.
Power consumption: 58W Max
Operating Current: 2.1A Max
IP Rate: IP65
I currently am using a SLESA-UE7 DMX interface to run the lights. I operate it using ESAPRO.
Is this correct ? The lights used to work well when running off the computer then started flickering and certain rows were not responding. So i placed just the DMX interface on the lights and used the 8 modes on the sd card. It seems to be working for now but limits me to very few options. I am unable to use the UV lighting feature in ESAPRO either. Should i be using a different dmx interface or even the s.t.i.c.k for this kind of setup ?
I appreciate your time and help.
Kind Regards
Ryan
LED Fixture + Correct Setup ???
Moderators: simonB, nick, TomHat, florent, Ben
-
- New Forumor
- Posts: 8
- Joined: Tue Dec 30, 2014 4:43 pm
Re: LED Fixture + Correct Setup ???
What fixture profile did you use for the fixtures in the ESAPro software?
How many dmx channels do your lights use? Is it 6 channels only? If so, I would suggest patching "6dimmer" fixture, under the "_varied" heading in the ScanLibrary.
That way, you will have control over each channel of control for your fixtures.
(I am assuming the fixtures are DMX controllable, directly)
How many dmx channels do your lights use? Is it 6 channels only? If so, I would suggest patching "6dimmer" fixture, under the "_varied" heading in the ScanLibrary.
That way, you will have control over each channel of control for your fixtures.
(I am assuming the fixtures are DMX controllable, directly)