Sunlite Forum

Hi there


If I selct a color with a button it dosent show it in easyview, but you can See it is sending the right the right dmx value out in the dmx out window, but some of the colors work and are viewed i easyview. The fixture is martin roboscan 218 mode 3

I just tried it using the ROBOSCAN PRO 218 II mode 3 and it seems to work perfectly.

Hi there

To bruno.falip i found out what coused the problem, it is at problem with the profile for the fixture, some time ago I corrected it becouse the dmx values did not fit with values on martin support page, an then i installed sunlite an then the corrected profile overwriten with faulty one again.



Where can I upload the corrected profile.

The last profile is in the intsallation program. If it is not correct, you can modify it with the Scan Library Editor. This will only take a few minutes.