Page 1 of 1
Probs in 3-D Viewer
Posted: Thu May 24, 2007 6:37 pm
by playboy
I have Robe Colorspot 1200 AT. In reality works perfekt, but not in the Viewer(Mode 1 and 2 its the same Effekt)
The CMY-Macro, Gobo Index 1 and 2 (Rotation), XY-Macro and XY Macro-Speed works not in the Visualisation. In reality work it. It this a Bug ?
Posted: Fri May 25, 2007 7:11 am
by bruno.falip
Gobo Index and rotation should work. If not, then the profile is not correct. For the rest, there is no possibility to show a macro...
Posted: Fri May 25, 2007 8:46 am
by playboy
Thanks for replay and Information that Macro is not to see, but the Goborotation is not to see. The Gobo is ok, but it not in rotation/shake in visual.
The Profile must by ok. the realwork on Colorspot is ok are not in Viewer?
Re: Probs in 3-D Viewer
Posted: Sat Nov 29, 2008 2:14 pm
by riverboatG
i have a smilar problem
so
all of 1200At's always runs on 3D on frost !
what is this ? a bug?
Re: Probs in 3-D Viewer
Posted: Fri Dec 12, 2008 2:54 am
by teggers
[quote="riverboatG"]i have a smilar problem
so
all of 1200At's always runs on 3D on frost !
what is this ? a bug?[/quote]
There is an actual "Frost" tick (check) box in the visualizer under construction mode under fixtures. It is the little round circle next to the paint bucket. I use it to diffuse a par beam from spot to flood. Maybe you have that box "tick"ed by accident for your fixtures. It is immediate when you tick it, so should see it right away.
Re: Probs in 3-D Viewer
Posted: Fri Dec 12, 2008 8:17 am
by bruno.falip
We have updated these profiles, they will be online soon.