Sunlite Forum

Posted: **Mon Nov 12, 2007 8:15 pm**

Hello,

on the Doc it is said that DHC_DMXCODE enables to change the start code.
When using this function with ie. a Slesa-U5, which port is actually affected, the OUT port, the IN port or both?

Thanks in advance

Posted: **Thu Nov 29, 2007 6:15 pm**

Posted: **Fri Nov 30, 2007 3:32 pm**

It's the OUT port

Posted: **Fri Nov 30, 2007 5:12 pm**

Thank you for your answer.

So on a SLESA-U5 if the IN port has been set to OUT, does the DHC_DMXCODE command changes the start code on both ports or only on the default OUT port?

Thanks again in advance.

Posted: **Mon Dec 03, 2007 8:56 am**

Only the OUT port.