Binary overview
Posted: Sat Sep 25, 2010 12:31 pm
Hi,
what would be handy in this release, is to have an overview page to set the dipswitches on your devices.
Now I had to check first the number in the dmx table, then open the calculator in windows to transfer it to binary code, and then go to the fixture to set the setting.
If you could print the page with all settings, you could go from fixture to fixture.
So, this would make life and debugging a lot easier.
Regards.
what would be handy in this release, is to have an overview page to set the dipswitches on your devices.
Now I had to check first the number in the dmx table, then open the calculator in windows to transfer it to binary code, and then go to the fixture to set the setting.
If you could print the page with all settings, you could go from fixture to fixture.
So, this would make life and debugging a lot easier.
Regards.