Sunlite Forum

Hi,
small question. A long time ago I asked about the light organ functionality. I've seen that in latest release there was already detection of the different frequentie bands. But I haven't seen yet that you could assign certain dmx channels to a detected range.
Can you give an update about it?

Thanks.

Yes this is possible.

-Set the frequency bands in the sound to light->bargraph window
-Go to easytime, create a gradient effect on each channel, ste the min to 0 max to 100
-click the small checkbox next to the loop checkbox to allow the cursor to follow the bargraph instead of time, it will start to move forwards
-right click the small checkbox to select your frequency band

Thanks , I've found it.