Sunlite Forum

Having problems getting my lights to do the same patterns or movements as what the 3D is doing. In the construction mode listing I have clicked on the Fixture then using the down Blue arrow I have tried to change the "invert Pan & Tilt" to match everything up. Once I have that done I then text that they are match up. For my text I get the lights to go forward and back and side to side and everything seem to be working ok. Then when i get the light to do a figure of 8 or another pattern this is when the lights and 3D goes out of Sync. Can someone please tell me how to sort this problem out.

Open ScanLibrary and open your fixture profile. Check that the minimum and maximum pan and tilt degrees match the ones written in your manual

Thanks Simon, That sorted it for me .

Allan