Page 1 of 1
can't patch from 1.07 to 1.08
Posted: Sat Apr 28, 2012 12:14 pm
by Astey
hi,
im unable to update firmware from 1.07 to 1.08
i used 4 different computers and everytime it fails xp/w7. i hit patch firmware, the box is blinking after a while tools.exe returns with the message please patch to 1.08
its impossible to use suite2 anymore until its fixed
i use a siudi 8c
regards
Re: can't patch from 1.07 to 1.08
Posted: Wed May 16, 2012 4:48 pm
by simonB
With some interfaces, it's not possible to upgrade the firmware from 1.07 to 1.08. To do this, you must start in 'bootloader mode'.
-power off your interface
-create a shortcut on p2-p3-p4-GND ports
-power on your interface
-start tools.exe
-update the firmware
-power off your interface
-remove the shortcut
-power on your interface
-start tools.exe
-update the firmware again
Here is a diagram showing the ports you must connect.
- bootloader mode smaller.jpg (41.7 KiB) Viewed 8833 times
If you don't have the correct cables for this, a quick solution is to use a ball of foil. As long as the 2 pins on the right are not connected, your interface will successfully start in bootloader mode.
- bootloader_foil.png (831.04 KiB) Viewed 8833 times
Re: can't patch from 1.07 to 1.08
Posted: Wed Jul 19, 2017 8:44 am
by quelou
it work
i built this for enter in the bootloader mode
so i can use my sunlite BC with the actual sofware ( 2017 ) on win7 and win10
thx
Re: can't patch from 1.07 to 1.08
Posted: Tue Aug 01, 2017 3:12 pm
by nick
Hi,
Thank you for the photos of this method of triggering bootloader mode on interfaces that don't have bootloader pins on the PCB.
Another simpler method is to use aluminium foil which can be found in most kitchens.
Kind Regards,
Nick.