Problem with Cree LED Moving head
Posted: Thu Oct 24, 2013 7:36 am
Hi,
i purchased some 12 cree LEDs moving heads.
the dmx manual assignments says that pan and tilt are channels 7 and 8
I created my fixture config assigning all correct channels with the scan library editor
Starting a new project with these fixtures patched I noticed that pan and tilt are reversed.
The manufacturer says that the channels are correct, in the fixture control panel the pan and tilt are not reversed.
regards
i purchased some 12 cree LEDs moving heads.
the dmx manual assignments says that pan and tilt are channels 7 and 8
I created my fixture config assigning all correct channels with the scan library editor
Starting a new project with these fixtures patched I noticed that pan and tilt are reversed.
The manufacturer says that the channels are correct, in the fixture control panel the pan and tilt are not reversed.
regards