Greetings,
Seems I can create interfaces with easy remote in PC mode and trigger events and control fixtures etc...
However, I cant seem to figure out how to control the SLESA-UE7 unit
when in stand alone mode attached to the network.
Easy remote only sees the SLESA-UE7 when attached to ESA2 via USB and in PC mode.
Any advice on how to to troubleshoot this would be helpful as it was the deciding factor for going with this unit for an install.
specifically to creat a remote for the end client to trigger scenes remotely.
Thanks.
Easy Remote in Stand alone mode with SLESA-UE7
Moderators: simonB, nick, florent, dylan, Ben
-
- New Forumor
- Posts: 6
- Joined: Thu Mar 13, 2014 2:01 am
-
- New Forumor
- Posts: 6
- Joined: Thu Mar 13, 2014 2:01 am
Re: Easy Remote in Stand alone mode with SLESA-UE7
Ive updated the Firmware to v1.21 BETA using the latest hardware manager and using ctrl+t to allow the Beta firmware version to be loaded.
I have easy remote build date of March 3 2014 running on an Ipad
The SLESA-UE7 is connected via DHCP and is recgonised on the network with ESA2.
However easy remote will still only recognize the SLESA-UE7 when ESA2 is running on a computer on the same network.
It will not pick up the device while in stand alone mode.
Any advice on how to get this to work in stand alone mode would be appreciated.
regards,
-Jason
I have easy remote build date of March 3 2014 running on an Ipad
The SLESA-UE7 is connected via DHCP and is recgonised on the network with ESA2.
However easy remote will still only recognize the SLESA-UE7 when ESA2 is running on a computer on the same network.
It will not pick up the device while in stand alone mode.
Any advice on how to get this to work in stand alone mode would be appreciated.
regards,
-Jason
-
- New Forumor
- Posts: 6
- Joined: Thu Mar 13, 2014 2:01 am
Re: Easy Remote in Stand alone mode with SLESA-UE7
Tried updating the firmware to 1.21 BETA
v1.21 killed the DMX output
I reverted back to v1.20 and got output back.
still never gained control with easy remote without running ESA2
v1.21 killed the DMX output
I reverted back to v1.20 and got output back.
still never gained control with easy remote without running ESA2
Re: Easy Remote in Stand alone mode with SLESA-UE7
This topic is now locked, please see here for further info on ER compatibility with the current firmware:
http://www.nicolaudie.com/forum_support ... 37&t=38892
http://www.nicolaudie.com/forum_support ... 37&t=38892
Simon
--
Sales/Support
--
Sales/Support