LED Fixture + Correct Setup ???
Posted: Sun Jan 11, 2015 6:01 am
Hi,
I am running a trampoline Park in Australia http://www.kloud9ine.com.au . I purchased 70 wall washers from MICZE in China. I have had many troubles with the lights. I am wanting to run the lights for entertainment purposes and also just have them on a fade sequence between colours. I was given a fixture profile from Micze China however i am unable to run UV light out of the lights.
This is the light Model:
LWW-1-10P(RGBAWP)
10pcs (RGBAWP,6IN1)
high power 6W LED,
Independant mode and DMX mode available.
Power consumption: 58W Max
Operating Current: 2.1A Max
IP Rate: IP65
I currently am using a SLESA-UE7 DMX interface to run the lights. I operate it using ESAPRO.
Is this correct ? The lights used to work well when running off the computer then started flickering and certain rows were not responding. So i placed just the DMX interface on the lights and used the 8 modes on the sd card. It seems to be working for now but limits me to very few options. I am unable to use the UV lighting feature in ESAPRO either. Should i be using a different dmx interface or even the s.t.i.c.k for this kind of setup ?
I appreciate your time and help.
Kind Regards
Ryan
I am running a trampoline Park in Australia http://www.kloud9ine.com.au . I purchased 70 wall washers from MICZE in China. I have had many troubles with the lights. I am wanting to run the lights for entertainment purposes and also just have them on a fade sequence between colours. I was given a fixture profile from Micze China however i am unable to run UV light out of the lights.
This is the light Model:
LWW-1-10P(RGBAWP)
10pcs (RGBAWP,6IN1)
high power 6W LED,
Independant mode and DMX mode available.
Power consumption: 58W Max
Operating Current: 2.1A Max
IP Rate: IP65
I currently am using a SLESA-UE7 DMX interface to run the lights. I operate it using ESAPRO.
Is this correct ? The lights used to work well when running off the computer then started flickering and certain rows were not responding. So i placed just the DMX interface on the lights and used the 8 modes on the sd card. It seems to be working for now but limits me to very few options. I am unable to use the UV lighting feature in ESAPRO either. Should i be using a different dmx interface or even the s.t.i.c.k for this kind of setup ?
I appreciate your time and help.
Kind Regards
Ryan