Dry Contact is not function for STICK CU4
Posted: Wed Jan 18, 2017 7:51 am
I using ESA2 to program scenes with trigger and stored in STICK CU4.
However, the trigger is not work for CU4.
I tried to use hardware manager to check the port trigger and it is work.
The port signal under hardware manager is correct and change from red to green when I tried to trigger.
Please help and urgent.
However, the trigger is not work for CU4.
I tried to use hardware manager to check the port trigger and it is work.
The port signal under hardware manager is correct and change from red to green when I tried to trigger.
Please help and urgent.