Turning Fixtures after programming
Posted: Mon Jan 30, 2017 7:06 am
Hello!
I have got a question:
When I pre-programm a Show with Movingheads with some scenes and then save the Showfile to go to the event location
where the real fixtures are hanged up and see for example two of four are turned about 90 degrees to my 3D Simulation.
Is there a way to tell Sunlite Suite to add a 90 degree angle to all Movements or Fix Positions to work against the "real" rotated fixture?
I hope my Explanation is somehow comprehensible!
Greetings from Germany!
guitarman
I have got a question:
When I pre-programm a Show with Movingheads with some scenes and then save the Showfile to go to the event location
where the real fixtures are hanged up and see for example two of four are turned about 90 degrees to my 3D Simulation.
Is there a way to tell Sunlite Suite to add a 90 degree angle to all Movements or Fix Positions to work against the "real" rotated fixture?
I hope my Explanation is somehow comprehensible!
Greetings from Germany!
guitarman