Sunlite Forum

Hi

Please can you help. I cannot switch between scenes using the external i/o port althought the previous/next switches are going between scenes.

I have measured 0v on pin 2 and 3.3v on all other pins. shorting pin 2 to any other pin (not 10) dosnt do anything.

The Hardware manuel isnt clear. The table dosnt agree with the list titled 'external connector pin assignment' (page 10).

Does shorting pin 2 to

pin1 = scene 1
pin2= scene 2
pin3= scene 3 etc.

is an address a scene?


My unit is a SLESA USB running in stand alone mode with a 9v psu. It has 8 simple scenes programmed.

Am i doing somthing wrong? or do you think the unit could be broken. Is there a way of checking??

Please can you help since soon since i have to get the device installed on site soon.

Thanks very much for your time and help.

YOU HAVE TO ASSIGN TO EACH SCENE THE BUTTON THAT WILL TRIGGER IT.
LOOK IN THE EDITOR SCREEN, THE TRIGGER BUTTON, AND ASSIGN IT.

Thankyou for your time and effort. Problem is solved and everything is working fine.