Hi
Please can you help. I cannot switch between scenes using the external i/o port althought the previous/next switches are going between scenes.
I have measured 0v on pin 2 and 3.3v on all other pins. shorting pin 2 to any other pin (not 10) dosnt do anything.
The Hardware manuel isnt clear. The table dosnt agree with the list titled 'external connector pin assignment' (page 10).
Does shorting pin 2 to
pin1 = scene 1
pin2= scene 2
pin3= scene 3 etc.
is an address a scene?
My unit is a SLESA USB running in stand alone mode with a 9v psu. It has 8 simple scenes programmed.
Am i doing somthing wrong? or do you think the unit could be broken. Is there a way of checking??
Please can you help since soon since i have to get the device installed on site soon.
Thanks very much for your time and help.
External i/o Port.
Moderators: simonB, florent, dylan