Sunlite Forum

Hello

I just received consignment of 3 pcs of SIUDI5 C.

When I tried to run any one of them using the smple VB code (obtained from http://www.nicolaudie.com/big/visualbasic_siudi.zip , it says "Interface Not FOund" and no DMX stream is generated either

The following have been done

1) Intel USB system check -Fully succesful

2) USB detection of device succesful

3) All USB drivers copied during first time detection of device

4) DasHardVB.dll copied to System32

Computer = 930MHz , 256 RAM , WinXP Home

What could be wrong ?

Hello

After my last post, I have discovered a hardware manual 'hidden' in the CD rom supplied

The status that I can now see is...

- Power LED (Yellow) is lit

- DMX LED (Red) is blinking steadyly at a fast rate. On testing DMX output,
Ave. BREAK = 91 microsec & Ave. MAB = 17.5 microsec is obtained
with no data activity.

- A green LED which should be blinking if software control is established
is NOT blinking. In fact, I can see 'a LED' near the USB connector but I
am not sure if it the green one since it has not lit up till now.

- running slmini.exe also gives a " NO INTERFACE ! " prompt

- DHC_OPEN command gives a negative return value (-1) when
monitored in the VB6 sample code

- There are no figures for SIUDI-5C in DHC_OPEN int param or return
value(int). SIUDI-EC values (=11) don't hold good.

- In fact, there is not much tech data on SIUDI-5C.

I have a deadline.........

Please email [email protected]

Already done so on Friday morning........no reply till now

Friday was off in France and we don't work on the weekend !!!

We don't have any sample source code in Visual Basic for this product.

Here is the link for the C++ sample:
http://www.nicolaudie.com/downloads/fil ... er_kit.zip